Memory Game

This kit has four buttons and LEDs to make up a game, which can be used as both a memory game and a reactions game. A PIC micro-controller, pre-programmed with special software controls the game. The on/off switch and battery pack mount directly onto the board allowing it to be used as built or the game can be housed into an enclosure designed by the student.

This kit includes:

• 1 x 2AA battery holder (PCB mount)
• 6 x 680ohm resistors
• 1 x 47ohm resistor
• 1 x 5mm red LED
• 1 x 5mm green LED
• 1 x 5mm yellow LED
• 1 x 5mm orange LED
• 4 x 6mm PCB mount switch - height 9.5mm
• 1 x PIC 12F675 pre-programmed with game code
• 1 x 8 pin IC holder
• 1 x right angled PCB mount switch
• 1 x M3 nut and bolt
• 1 x game PCB

PCB dimensions: 58.5mm x 58.5mm.
Requires x2 AA batteries, available separately.